Description
This ultrasonic probe system is built around a used Dukane 20A3000 20 kHz 3000 watt generator built in 1996. It has a later model all-digital Auto-Trac driver board with linear ramp soft start and fully automatic tuning with adjustable tuning phase angle. It has an analog high voltage power supply and matching module with the high power switching transistors set in an external heat sink. Rear panel analog power monitoring jack. Rear panel variac jack is disabled internally but could easily be re-enabled if you can find the right variac and probably more importantly the right connector for it). It has a front panel “power” knob allowing amplitude setting from 100% to about 40%. This generator has been recently serviced and checked out for operation. Very clean for its age and ready to run. Runs on 200-240 VAC single phase 50/60 Hz 25 amps, mounted power cord ends in a whip (wires). Warranty is 30-day money back or exchange in the USA, no return or refund on international sale.
The generator is matched to a new tributek AM30122C 3000W transducer (replaces Dukane 41C30) with three year limited warranty (or 2,080 ultrasound hours, whichever is less).
New BT30250 titanium booster by tributek with 3.25″ ring (specify gain ratio) 1/2-20 input and output threads, one year warranty.
New CSHV03M ultrasound cable SHV/SHV by tributek, 3 meters, one year warranty.
USC2MJ20 generator start cable by tributek, 2 meters (connector is used, cord is new), one year warranty. Generator runs ultrasound on dry contact closure (24 vdc) between the two wires, stops when contact goes open. Strongly recommend this contact closure be hold relay style so if station control voltage is lost (for example in emergency stop condition or control voltage power supply failure) the generator stops. One year warranty.
All above made in USA.
One system available only and subject to prior sale.