vise
Showing all 3 results
2400 watt 20 kHz Dukane iQ Press System built 2018
2400 watt 20 kHz Dukane iQ press system. This welder is in very good condition and ready to go.
Pneumatic press with limit switch kit, dual pressure welding, distance, absolute distance welding modes.
Optical safety switches (anti-tie-down) and twist to reset e-stop are installed in the base. All original Dukane cables.
System includes a 20 kHz 2400 Watt Dukane iQ generator/controller with all the advantages of the iQ in precision and reliability.
20KHz Stack Vise for Ultrasonic Tooling
This stainless steel stack vise is designed specifically to clamp 20KHz converter front slugs and booster spanner "collars" during assembly or disassembly to reduce damage to expensive ultrasonic stack components.
The vise features two clamping chambers, one for tooling 1.5" (38 mm) dia. and one for tooling 1.8" (46 mm) dia. The two-pin hinge design allows the upper jaw to "float" and seek the best clamp position on the tool for maximum contact. The securing bolt has a long lever handle that can be re-positioned out of the way once secured. The securing bolt can be completely removed so the upper vise jaw can be fully opened. The steel spanner-hole pins are set in stepped holes such that they can be driven out from the bottom of the vise should they ever need replacement.
Ultrasonic Tooling Vise for CJ-20/CR-20/CH-20/CS-20
This stainless steel stack vise is designed specifically to clamp 20KHz converter front slugs and booster spanner "collars" during assembly or disassembly to reduce damage to expensive ultrasonic stack components.
The vise features two clamping chambers, one for tooling 1.625" (41 mm) dia. and one for tooling 1.8" (46 mm) dia. The two-pin hinge design allows the upper jaw to "float" and seek the best clamp position on the tool for maximum contact. The securing bolt has a long lever handle that can be re-positioned out of the way once secured. The securing bolt can be completely removed so the upper vise jaw can be fully opened. The steel spanner-hole pins are set in stepped holes such that they can be driven out from the bottom of the vise should they ever need replacement.