20TV900
20KHz Stack Vise for Ultrasonic Tooling
This stainless steel stack vise is designed specifically to clamp 20KHz converter front slugs and booster spanner "collars" during assembly or disassembly to reduce damage to expensive ultrasonic stack components. The vise features two clamping chambers, one for tooling 1.5" (38 mm) dia. and one for tooling 1.8" (46 mm) dia. The two-pin hinge design allows the upper jaw to "float" and seek the best clamp position on the tool for maximum contact. The securing bolt has a long lever handle that can be re-positioned out of the way once secured. The securing bolt can be completely removed so the upper vise jaw can be fully opened. The steel spanner-hole pins are set in stepped holes such that they can be driven out from the bottom of the vise should they ever need replacement.
$380.00 Add to cart
stud
Horn/Booster Stud for Ultrasonic Tooling
These specially heat-treated steel studs have cup points, and are chemically blackened. No warranty.
$1.95 Select options
20TV900
Ultrasonic Tooling Vise for CJ-20/CR-20/CH-20/CS-20
This stainless steel stack vise is designed specifically to clamp 20KHz converter front slugs and booster spanner "collars" during assembly or disassembly to reduce damage to expensive ultrasonic stack components. The vise features two clamping chambers, one for tooling 1.625" (41 mm) dia. and one for tooling 1.8" (46 mm) dia. The two-pin hinge design allows the upper jaw to "float" and seek the best clamp position on the tool for maximum contact. The securing bolt has a long lever handle that can be re-positioned out of the way once secured. The securing bolt can be completely removed so the upper vise jaw can be fully opened. The steel spanner-hole pins are set in stepped holes such that they can be driven out from the bottom of the vise should they ever need replacement.
$410.00 Add to cart
ST20STEP
Step Stud 1/2-20 to 3/8-24
This is a specially heat treated steel socket-head stud with 1/2-20 threads on one end and 3/8-24 threads on the other. Used for adapting horns to boosters that do not have the same thread size. No warranty.
$16.00 Add to cart
Polymer (Mylar) Washers for Stack Joints (35 pack)
These washers made of heat-resistant Mylar(TM) can be used instead of high pressure silicone grease in ultrasonic stack joints. IMPORTANT: Use a new washer each time the tooling is reassembled. Do not use both grease and a washer in the same joint. Washers come 35 to a pack. Order the number of packs you want, not the number of washers.
$26.50 Select options
High Pressure Silicone Ultrasonic Stack Grease
The function of grease in the joint is to: 1. Fill the microscopic valleys in the surface of the tooling to improve acoustic transfer from one component to the next. 2. Remain in the joint so the metal of the two pieces of tooling do not become "clad" together by the action of the ultrasound and thus impossible to disassemble. Never use grease and a polymer washer in the same joint.
$1.95 Add to cart
17CSHV
Back-to-Back SHV Bulkhead Connector
This back-to back SHV connector connects with the standard ultrasound cable-mounted SHV connector to connect through a panel into an enclosure or make another SHV ultrasound cable into an extension cable. This item comes with all you see in the photo: connector, silicone rubber gasket, lock washer and nut.
$35.00 Add to cart