branson
Showing 25–30 of 30 results
20KHz Full Wave Water Cooled Booster with Titanium Output End
This 20 KHz full wave liquid/water cooled booster assembly provides ultimate stack temperature management.
PLEASE SPECIFY GAIN RATIO: 0.4, 0.5, 0.6, 1.0, 1.25, 1.5, 1.75, 2.0, 2.5
40 KHz Aluminum Booster 1.937 inch ring for Branson or Dukane
These 40KHz aluminum boosters are precision made from certified materials and tuned to tight frequency tolerances for trouble free operation. These boosters are recommended for all 40KHz applications for their heat-dissipating properties.
They are constructed with a 1.937" diameter mounting ring set that is made to be disassembled for o-ring replacement. Input stud is 8mm, output thread is 8mm.
Fits virtually all Branson and Dukane 40 KHz systems, and many others. Check mounting ring and stud sizes to be sure.
All-new, precision made in USA. One year limited warranty.
PLEASE SPECIFY GAIN RATIO: 0.5, 0.7, 1.0, 1.5, 2.0, 2.5
20KHz Stack Vise for Ultrasonic Tooling
This stainless steel stack vise is designed specifically to clamp 20KHz converter front slugs and booster spanner "collars" during assembly or disassembly to reduce damage to expensive ultrasonic stack components.
The vise features two clamping chambers, one for tooling 1.5" (38 mm) dia. and one for tooling 1.8" (46 mm) dia. The two-pin hinge design allows the upper jaw to "float" and seek the best clamp position on the tool for maximum contact. The securing bolt has a long lever handle that can be re-positioned out of the way once secured. The securing bolt can be completely removed so the upper vise jaw can be fully opened. The steel spanner-hole pins are set in stepped holes such that they can be driven out from the bottom of the vise should they ever need replacement.
Ultrasonic Tooling Vise for CJ-20/CR-20/CH-20/CS-20
This stainless steel stack vise is designed specifically to clamp 20KHz converter front slugs and booster spanner "collars" during assembly or disassembly to reduce damage to expensive ultrasonic stack components.
The vise features two clamping chambers, one for tooling 1.625" (41 mm) dia. and one for tooling 1.8" (46 mm) dia. The two-pin hinge design allows the upper jaw to "float" and seek the best clamp position on the tool for maximum contact. The securing bolt has a long lever handle that can be re-positioned out of the way once secured. The securing bolt can be completely removed so the upper vise jaw can be fully opened. The steel spanner-hole pins are set in stepped holes such that they can be driven out from the bottom of the vise should they ever need replacement.
Polymer (Mylar) Washers for Ultrasonic Stack Joints (35 pack)
These washers made of heat-resistant Mylar(TM) can be used instead of high pressure silicone grease in ultrasonic stack joints.
IMPORTANT: Use a new washer each time the tooling is reassembled. Do not use both grease and a washer in the same joint.
Washers come 35 to a pack. Order the number of packs you want, not the number of washers.
High Pressure Silicone Ultrasonic Stack Grease
The function of grease in the joint is to:
1. Fill the microscopic valleys in the surface of the tooling to improve acoustic transfer from one component to the next.
2. Remain in the joint so the metal of the two pieces of tooling do not become "clad" together by the action of the ultrasound and thus impossible to disassemble.
Never use grease and a polymer washer in the same joint.